PetFit.

How to Measure a Dog for a Crate, Bed or Harness

Updated 2026-11-19

Three numbers, about ninety seconds, no helper needed. Get these right and almost every sizing question answers itself.

1. Set the dog up

Level floor, front legs straight, head level. A dog that is sitting, curling or leaning compresses the spine and the length comes out short — the single most common measuring mistake.

2. Body length: nose to tail base

Hold the tape at the tip of the nose and run it along the top of the back to the point where the tail meets the body. Do not include the tail. Do not follow the curve of the neck too closely; imagine a straight line from nose to tail base and read where it lands.

Wrong: nose to tail tip. That adds 8–15 in and turns a 36 in crate into a wrong 48 in purchase.

3. Shoulder height

Floor to the highest point of the shoulder blades — not the top of the head, which moves, and not the withers at the neck, which sits lower than people expect.

This is the number that decides whether the dog can stand in a crate. A crate with enough floor but not enough height is the one return that cannot be fixed with a bigger bed.

4. Chest girth (harness only)

Around the widest part of the rib cage, one hand-width behind the front legs, over the withers and under the chest. Snug with two fingers of slack.

If you have no soft tape

  1. Use a piece of string or a phone charging cable.
  2. Mark the length on the string with a pen.
  3. Lay the string flat against a ruler or a tape measure.

Tape measures meant for sewing are cheap and far more accurate than eyeballing; if you are buying an $80 crate, it is worth the two dollars.

The three numbers in one place

Measurement Where it starts Where it ends Used for
Body length Tip of nose Base of tail Crate, bed, car fit
Shoulder height Floor Top of shoulder blades Crate, door, car
Chest girth Behind front legs Around the rib cage Harness

Where to put the numbers

Frequently asked

Do I measure nose to tail or nose to tail base?

Nose to the base of the tail. The tail is not part of the body a crate has to hold, and including it adds 8–15 in of error.

Should the dog be standing or lying down?

Standing, on level ground, with the head level and the front legs straight. Lying down compresses the spine and shortens the measurement.

Can I use the weight from the vet instead?

As a fallback, yes. But weight cannot separate a deep-chested dog from a stocky one, so it is the least accurate of the four inputs.

How tight should the girth tape be?

Snug enough that two fingers slide under it. Tighter gives a harness that rubs; looser gives one that slides sideways.